Installing TV antenna
You will find 3 basic parts toward Channel Master rotor.
The motor that turns the antenna. The interior control device as well as the handheld remote control.
It requires two split pieces of pipe to put in the engine device. The stationary pipe originating from below that's held because of the antenna mount and another pipeline to give from the engine around the antenna. The very best throat associated with motor is what turns. The rotor can accommodate pipe of up to 2" external diameter.
The rotor control device is found within the house at a place that you choose. This place is generally near the primary television. A rotor wire is then went through the outside motor into the household toward control unit. You will find 3 individual color coded wires inside of the jacket associated with the rotor wire. On both motor additionally the control unit you will find contacts labeled 1, 2, and 3. It doesn't matter what color wire is linked to exactly what number as long as the exact same color is attached to the exact same number for each unit. In the event that Red wire is connected to #1 during the engine it should be connected to #1 at the control device etc. It is advisable to take note of the quantity - shade structure therefore if the cables get disconnected it is possible to reconnect within the proper order.
The directions incorporated with the rotor will show you just how to orient the rotor with the antenna during the time of set up.
The remote control is infrared and should be in line of sight into the control unit. The remote may be pre-programmed every single specific section transmitter course. Whenever pre-programmed the operator can merely press the specified channel quantity into the rotor radio control and also the antenna will immediately look to the pre-programmed way. The rotor can be by hand operated on control unit.